The on-off cycle in the master timer should go on only for the set time (here it is 18 minutes). Once the master timer goes off, the cycle should stop. To achieve this, the outputs of both the timers are connected to NAND gate N1 (IC3), which gives a low output only when both the timers are giving high outputs.The output pin 3 of N1 is connected to relay RL1 via pnp transistor T1, so the relay energises only when the output from NAND gate N1 is low. As the mains 220V line is taken through relay RL1,the monitor turns off during the 3-second off period after the set time of 10 seconds is over.
The motor cannot be reversed instantly. It needs a brief pause between switching directions, or else it may get damaged. For this purpose, another spin direction control timer (IC2) is employed. It is realised with an IC 555. This timer gives an alternate ‘on’ and ‘off’ time duration of 10 seconds and 3 seconds, respectively. So after every l0 seconds of running (either in clockwise or anticlock-wise direction), the motor stops for a brief duration of 3 seconds. The values of R3 and R4 are calculated accordingly.