During ‘on’ time of spin direction timer IC2, the output of negative- edge triggerd JK flip-flop at pin 2 goes low to energise relay RL2 and washing machine motor rotates in one direction. During the off time of IC2, the output of N1 goes high again to de-energise relay RL1, which cuts off the mains supply to RL2 and the monitor stop rotating. Floating point trouble may occur at trigger pin 2 of IC1. Resister R8 over comes this problem by holding pin 2 high.
Typically, washing machine pressure switches have a large sensing diaphragm that's about 60mm or so in diameter and three quick-connect male terminals. One connection is common, while the others are for normally open (NO) and normally closed (NC) connections. A set-point adjustment mechanism is built in (it's directly controlled by the 'water level' knob) and the switch opens and closes with audible clicks.